It all comes down to Bulldozer vs excavator, which is actually about the job that needs to be done. A bulldozer moves, shapes and levels bulk material on the ground. An excavator digs underneath its tracks, loads trucks and lifts. They share the same field on the edge, but each one works much better at its own job.
Most earthworks in the UAE, including plot leveling and road construction, use both machines. The following will show you which machine does what better, how the ground and distance determine this, and our range of Shantui and Liebherr machinery.
What is each machine good at?
A bull dozer uses its weight and traction to push material forward with the blade. It works best in digging on high ground and filling in low ground in layers. Rear ripper, if there is one, prepares the compacted ground prior to pushing.
An excavator works from one spot, swinging its upper body through a full circle. This machine digs foundations, trenches, and loads trucks without traveling and also lifts materials as long as they weigh within its capacity.
Both machines work together in situations like backfilling trenches or creating banks. The excavator pulls materials back into the trench using the bucket and can be fitted with a small blade to clean up. The dozer pushes the spoil back over the pipe once the pipe is installed. If the task is small and not heavy, either machine will work.
Bulldozer or excavator: which suits your site?
| Question | Bulldozer | Excavator |
| Main job | Push, spread and rough level bulk material | Dig, trench, load trucks and lift |
| Works below its own level? | Cuts at ground level, layer by layer | Digs well below its tracks |
| Loading trucks | Not designed for it | A core task |
| Moving material | Efficient over short pushes | Only within the reach of the boom |
| Finished levels | Rough grading, and finer grading with a skilled operator or machine control | Can trim slopes, but not a levelling machine |
Distance is the factor that can be easily forgotten. Dozing would normally be cheaper for distances that are relatively short, such as less than 100 m. At a greater distance, it would generally be cheaper to use an excavator to load vehicles. Our guide to earth moving equipment shows how the machines work together, and the backhoe loaders vs excavators comparison covers smaller sites.
What should be considered before making the choice?
- Main purpose. Note whether the major operation consists of digging and loading or pushing and spreading.
- Pushing or hauling distance. Measure the distance that material should be pushed or hauled since it may determine the choice of the machine alone.
- Soil and materials. If rock or cemented soil is encountered, it may require the use of a ripper or breaker attachment; soft soils prefer the machine with wider tracks.
- Required production. Estimate the production based on blade capacity of the bulldozer or bucket capacity of the excavator against the volume required per day.
- Transporting. The equipment usually transports between sites in a low-loader, therefore measuring weight and width.
- Remaining fleet. Excavator requires trucks or dumpers to provide enough work, while a dozer needs a grader and roller following behind.
- Spares and servicing. Verify availability of spares and servicing for the manufacturer in the area.
Which GENAVCO models fit?
GENAVCO supplies dozers and excavators from Shantui equipment and Liebherr, so a contractor can size each machine to its job.
| Shantui Bulldozers | |
| Models: SD16 (160 hp), SD22 (220 hp) and SD90-C5 (900 hp)
Types: mechanical, hydraulic, hydrostatic and electric Used in: mines, forests, deserts, wetlands and coal fields |
|
| Best for: Earthworks and land clearing where pushing and spreading drive the programme | |
Shantui excavators start from 5.8 tonnes with a 0.2 m3 bucket; ask GENAVCO for the current top of the range and budget guidance. Tell us the work and we will match the machines, or request an earthmoving quote.
How much does it cost to operate each machine?
Fuel, wear parts, and downtime are the factors responsible for hourly costs in each machine. The difference in the rate of wear is important in budget planning.
- Undercarriage: both use tracks, but continuous pressure while working in abrasively sandy UAE environment causes rapid wear of a dozer's undercarriage. Monitor track tension and frequently clear away packed material.
- Cutting edges and teeth: cutting edges and teeth of blades of a dozer and bucket teeth of an excavator are consumable parts and must be changed before wearing the frame.
- Hydraulic system: since an excavator depends so much on its hydraulic system, then oil, filters and hoses must be especially clean.
- Heat and dust: radiators and air filters of both machines require special maintenance in summer.
- Driver's skills: a skilled driver transports more material per liter of fuel than a not-so-skilled one.
GENAVCO supplies genuine parts and support from certified technicians, in the workshop and on site with service vans.
Common questions
Does a bulldozer perform the functions of an excavator?
Yes, when dealing with a small amount of spreading or backfilling, but for bulk pushing and leveling, a bulldozer is much more efficient than an excavator.
Can a bulldozer dig a foundation?
It cannot dig footings or trenches. A dozer can level soil in layers for a broad and shallow trench, but a foundation, trench, and deep hole require an excavator.
Which one performs better on soft sand?
Both machines have tracks; however, a dozer is made for pushing through soft and uneven terrain. Soft sand requires larger tracks on both machines.
Are a crawler tractor and a bulldozer the same thing?
Yes, Liebherr describes its bulldozers as crawler tractors, like the PR 736. They perform the same function as other bulldozers.
Do I need them both for the same job?
Many times, yes. Construction sites utilize a dozer to level the ground and an excavator to dig and load materials at separate phases of the project.
Tell us the job, the ground and the volumes, and we will recommend the right bulldozer or excavator.
Serving Dubai, Abu Dhabi, Sharjah, Al Ain and the wider UAE.



